Let’s Talk About Our 600mm Carbon Heating Lamps
If you’re looking for a way to get consistent heat across a decent amount of space, these 600mm lamps are a great bet. We built them to hit that “sweet spot” of medium-wave infrared. At 1000W and 220V, they give you a nice, balanced spread of heat that fits right into most industrial drying and curing lines without any fuss. The nitty-gritty on power Here is the thing about the electrical side: you’re looking at a 4.5A load per lamp. Just make sure your wiring and controllers are up for it. You don’t want to deal with the headache of burnt-out terminals because the power draw was too much for your setup. We use a carbon filament wrapped in quartz. Why? Because it lets the heat sink deeper into your materials than those short-wave lamps do, but it won’t kill your electricity bill like a long-wave system would. Why carbon actually matters Carbon handles heat differently than tungsten. It spreads the warmth evenly across the whole 600mm length. This is huge because it stops those annoying “hot spots” from appearing—the kind that warp your plastics or leave scorch marks on your coatings. One quick tip: be gentle with them. Since the carbon and quartz expand at different rates when they get hot, these tubes don’t love being shaken.**Keep them snug in their housing.**If they rattle, they’ll break. Putting them to work You’ll see these doing the heavy lifting in PET blowing, paint curing, and plastic welding. The 600mm size is handy because it covers a wide area, meaning you don’t have to cram a dozen tiny tubes into your machine. But, there is a trade-off. These aren’t like halogen tubes that snap to full heat in a blink. They need a moment to warm up. Just keep that ramp-up time in mind when you’re planning your cycle. If your process needs to react in milliseconds, you might want to bump up the wattage or move the lamp a bit closer to the workpiece.